Linn LP12 Plinth measurement needed

[Mikewong]

I got a used LP12 platter and bearing system and I would like to DIY
the wooden plinth and could any one of you here provide me with the
actual measurements(plinth/top plate etc).

 

[Aengus]

Do you have them yet?

Hi Mike

Do you still need these measurements? If so, let me know what you need and I'll try to get them this weekend; but I'm fairly busy at the moment, so if you can be specific about which measurements you want that would be good.

 

[Mikewong]

Yes!
Please.

 

[Aengus]

Here you go. I hope these are the dimensions you were looking for; if not, let me know.

[edit] The attachment doesn't seem to be taking; I'll try again.

 

[Aengus]

OK, here's a 95K version...

The feet are not shown.

 

[willie000]

PLinth

Do you have the complete design drawings for the plinth, as to build from scratch.

Thanks

 

[Aengus]

Nope, I just took the dimensions from my LP-12 and made the sketch.

What else do you need to know?

Aengus

 

[willie000]

Hi,

I would need a coplete drawing, with the sub chassis supports ...all the internal dimensions really

Thanks

 

[Mikewong]

Aengus.
Thank you for the details measurements and this would be a great help for me to start constructing the Linn Lp12 plinth.

 

[Aengus]

willie000 said:

I would need a coplete drawing, with the sub chassis supports ...all the internal dimensions really

Hi

This would unfortunately call for a bit more dismantling than I can undertake just now. Sorry I can't be more helpful.

Perhaps someone else has the information readily available?

 

[Aengus]

Hi Mikewong

You are welcome. Good luck with your project.

Aengus