Are their any recommendations for current limiting?
Is 2x the expected load current a good start?
In my case I have 2x Tregs powering a single Aikido channel each.
Each channel will be drawing an expected15mA.
265Vdc at the output of the regulators.
1k Plate resistors for 250Vdc at the plates.
Is 30mA a good idea?
By my maths R11 = 456.9k. Closest value is 453k
R16 = 20R for 30mA
All sound about right?
Is 2x the expected load current a good start?
In my case I have 2x Tregs powering a single Aikido channel each.
Each channel will be drawing an expected15mA.
265Vdc at the output of the regulators.
1k Plate resistors for 250Vdc at the plates.
Is 30mA a good idea?
By my maths R11 = 456.9k. Closest value is 453k
R16 = 20R for 30mA
All sound about right?
Not sure if this is still open, but I did a quick sim with your values.
In LTSpice, which predicted my test voltages pretty accurately so far, I get 265V for R11 512k.
20R for R16 is working up to about 60mA before shutdown. 40R is good for 45mA.
Since it is only simulated, no guarantee whatsoever.