no indeed! its just an alim thing that i didnt respect im sure, you make vss and vaa out of ±B ?
edit: just realise my CSL was at min, maybe just that also, gonn borrow that oscillo tonight and check it out again
edit: just realise my CSL was at min, maybe just that also, gonn borrow that oscillo tonight and check it out again
Last edited:
update:
realized that my amp op was dead too.. strange thing, ordered some.. didnt have spare
i made ±5V with ±B and external diodes, work great for now
w8ting for op amps..
realized that my amp op was dead too.. strange thing, ordered some.. didnt have spare
i made ±5V with ±B and external diodes, work great for now
w8ting for op amps..
got my pwm working, everything in small signal is ok, tho i dont have amplified signal, looked up csh csl, was at max, csd is waving aroung 200mv referenced to gnd. got the same signal input as output 2Vp-p (by fb ?) nothing on HO LO, and Vb referenced to -B is 0V ???? tell me what you think.. not quiet sure bout the real source
edit:
realised csd was waving in same time as pwm
edit:
realised csd was waving in same time as pwm
Attachments
Last edited:
Vb can not be 0v compared to -B and for that you don't even need scope, are you sure you measure those two pins?
Where do you get this pwm? sounds like it wants to start, I think I had it like this, but I couldn't supply enough voltage for upper fet (since he wanted to oscillate at lower MHz range)
I still think your voltages are off, can you check that again
Also, you could be at the point I was, where I needed strong input signal, to make it operational, then it worked, untill switched off again
BUT FIRST, how much is your Cfilter and remove it... I had it, and I had problems setting any higher freq, also amp started harder
Where do you get this pwm? sounds like it wants to start, I think I had it like this, but I couldn't supply enough voltage for upper fet (since he wanted to oscillate at lower MHz range)
I still think your voltages are off, can you check that again
Also, you could be at the point I was, where I needed strong input signal, to make it operational, then it worked, untill switched off again
BUT FIRST, how much is your Cfilter and remove it... I had it, and I had problems setting any higher freq, also amp started harder
Last edited:
i didnt put Cfilter
pwm is from pin comp
i'm sure about Vb, no doubt, dont have
i didnt put R18 which charge cap on first oscillation tho
my input signal is kinda strong 2Vp-p
is CSD ok ? it is not supposed to be Vaa ?
pwm is from pin comp
i'm sure about Vb, no doubt, dont have
i didnt put R18 which charge cap on first oscillation tho
my input signal is kinda strong 2Vp-p
is CSD ok ? it is not supposed to be Vaa ?
just realised it... pwm freq is about 60Hz (which is my input signal)
i guess its not normal uh ?
i guess its not normal uh ?
My PWM frequccny is about 250KHz. I can see the residual PWM on the output signal just a few volts.
- Status
- Not open for further replies.