Looks like a few folks in the U.S. have already received their boards. I hope to receive mine soon!
Best,
Anand.
Best,
Anand.
Any sets remaining? I can pay immediately, I just need one set for myself
I also need a set of M2X boards (plus daughter boards) but that may be outside the scope of asking on this particular thread.
TIA
I also need a set of M2X boards (plus daughter boards) but that may be outside the scope of asking on this particular thread.
TIA
Just a quick reminder that any and every diyAudio member can order IPS6 and/or IPS7 PCBs directly from a PCB fab, and have them shipped straight to your house in your country. It's fun, it's easy, it's inexpensive. And it's also the next step up in maturity as a diyAudio builder.
(link to #4371)
The manufacturing CAD files ("Gerbers") are freely available for download. They are attached to M2x post #3408.
(link to #4371)
The manufacturing CAD files ("Gerbers") are freely available for download. They are attached to M2x post #3408.
Thank you for the link Mark.
I have done that in the past for other projects and would happily do so again if I can get my hands on the M2X PCBs.
I have done that in the past for other projects and would happily do so again if I can get my hands on the M2X PCBs.
I'm not sure about this but I'm thinking about fitting this IPS7 buffer in front of my F6 to replace the k170/j74 jfets and wondered if it's possible or advisable to arrange this to obtain an extra 6dB gain so that a typical 2 volt signal (ie CD player, DAC, etc) will produce full F6 output - at present, it needs about a 3.5v signal.
Could someone add some info about this, please ...
Could someone add some info about this, please ...
Mouser is running out of KSA1220AYS. What are the most important specs (other than the pin out) that I should look for to substitute the KSA1220AYS/KSC2690AYS?