So then the ball is back in the S03's court. It sounds as if the OTTO is agnostic to whatever is thrown at it. I'll most likely give it a go then.
Can the switch be used to switch analog outputs?
I would like to switch the outputs from a DAC and an analog source to use the same amplifier. So I need to go from 2 to 1.
I would like to switch the outputs from a DAC and an analog source to use the same amplifier. So I need to go from 2 to 1.
Hello,
I have got a problem with my OTTO2. the setup = toslink> S/PDIF Transceiver Module > metronome >B2 DAC. Without the Otto the sound is good but with it there is almost no music and a lot of crackling sound. The I2s lines are about 8cm totally, coax or single wire made no difference. Especially the BCK wire is very sensible. When i connect that wire directly from Tranceiver module to the metronome all static is gone. That wire is 7cm in length. Hopefully it's not the lenght of the i2s wires....
I have got a problem with my OTTO2. the setup = toslink> S/PDIF Transceiver Module > metronome >B2 DAC. Without the Otto the sound is good but with it there is almost no music and a lot of crackling sound. The I2s lines are about 8cm totally, coax or single wire made no difference. Especially the BCK wire is very sensible. When i connect that wire directly from Tranceiver module to the metronome all static is gone. That wire is 7cm in length. Hopefully it's not the lenght of the i2s wires....
Attachments
Correction : There is still distortion without the OTTO. It must be the wirelength between the Transceiver module & the Metronome. 4cm wire is still too long, i can't use this setup 🙁
