I assume it's a power supply issue? Is this power supply board close to another Infocus model that they have the same issue?
anyone??
It's the IN116 model
I have the power supply out right now and with a power cable plugged in I see no voltage over the main fuse.
Where should I check first?
the stuff on the heatsink
k20a60u & fsu10a60 and the bridge rectifier D10XB60b
+ to - on the bridge rectifier I'm getting 164 V
It's the IN116 model
I have the power supply out right now and with a power cable plugged in I see no voltage over the main fuse.
Where should I check first?
the stuff on the heatsink
k20a60u & fsu10a60 and the bridge rectifier D10XB60b
+ to - on the bridge rectifier I'm getting 164 V
Attachments
That's from a similar projector but showing the PFC, I was told that it might be something between the mains filter caps and the PFC with something being open circuit or shorted.
An externally hosted image should be here but it was not working when we last tested it.
- Status
- Not open for further replies.