Just not a 100% perfect sine wave.Doubt it'll be noticed playing on subs in a car.I've read these amps aren't very (clean) not sure what that means......I drove it to a 60 amp load which is all my power supplies(s) can do and it seems okay....the angles on the waves just aren't exsctly even up and down (which i had a more experienced way to explain)to each other.Perhaps I'm over complicating this lol.
But I appreciate the help and I'll throw it in a car tomorrow and see how it sounds.If all is bad....I'm sure you'll see this post again lol...
But I appreciate the help and I'll throw it in a car tomorrow and see how it sounds.If all is bad....I'm sure you'll see this post again lol...
Set the crossover to the highest frequency and the subsonic to the lowest frequency and re-check the sine wave. Use 100Hz.
- Status
- Not open for further replies.