Hi i need help wiring my crossover to my amp my crossover is a behringer super x pro cx2310 it going to a europower ep2000 behringer to subwoofer i will be coming from a mixer
it is all new thank you colin
it is all new thank you colin
Hi mixer is fine runing xlr from mixer to the input of crossover then xlr to amp then sub from amp kind rgs colin
from the amp to the sub are you using XLR or Speakon?
other then that everything sounds correct and should be working,is it?
other then that everything sounds correct and should be working,is it?
yes i am have a speakon from the amp to the sub 2 xlr from the mixer tp inputs of crossover then xlr 1 2 outputs to amp inputs rgs colin still not working
You don't want to assume everyone knows these model numbers. Describe what they are and how you want to connect them. Even a drawing would help.
ok... are the low mutes out on the x-over? are you seeing any signal LED's on the amp flickering? what gain settings do you have on the amp?
you need to be more forthcoming with details like, your source device, and mixer settings...
any chance you can upload pictures of your setup and patch?
and can you either show a pic or list your dip switch settings on the back of the amp?
as you said this stuff is all new so should work...
you need to be more forthcoming with details like, your source device, and mixer settings...
any chance you can upload pictures of your setup and patch?
and can you either show a pic or list your dip switch settings on the back of the amp?
as you said this stuff is all new so should work...
Last edited:
sorry new to this i will do a drawing and send it to you rgs colin yes it is all new i am getting noise from the xlr in puts on the mixer
Last edited: