My DIY turntable
is made of an old EDS1000-2 DD motor from a Dual CS721, the OPS tonearm was taken from a Dual CS5000 and is a extended Version (by me) to 9.5zoll(ca. 242mm instead 221mm of the orginal) with headshell from a CS505-2.
It works very good and quite. In- and outerplatter came from a Linn Sondek.
The three feets are from a Linn Basik.
The OPS tonearm is some very special, it sounds surprisingly good with Audio Technica AT-ML180OCC or Linn K-18II(these cartriges are my alltime favourite MMs since longtime!).
Both Cartridges has get a re-tipping with a ATN150MLX needle.
is made of an old EDS1000-2 DD motor from a Dual CS721, the OPS tonearm was taken from a Dual CS5000 and is a extended Version (by me) to 9.5zoll(ca. 242mm instead 221mm of the orginal) with headshell from a CS505-2.
It works very good and quite. In- and outerplatter came from a Linn Sondek.
The three feets are from a Linn Basik.
The OPS tonearm is some very special, it sounds surprisingly good with Audio Technica AT-ML180OCC or Linn K-18II(these cartriges are my alltime favourite MMs since longtime!).
Both Cartridges has get a re-tipping with a ATN150MLX needle.
Attachments
Last edited: