Hi - I've built a 6 channel symasym for use with a ESP LR4 crossover - worked well and sounded very nice until I tried scoping the left channel outputs of the crossover, at which point for a reason that I do not understand I melted R2 (10 ohm signal ground to power ground) on all three left channel amps - have replaced the resistors and the amps now appears to work perfectly apart from the fact that I have just recieved a shock from the signal input ground and can measure 74v from power -ve and chassis ground and 37v from signal ground and chassis ground - these measurments are all zero on the right channel amps so I obviously have a problem but am now not sure where to look for it. Any help would be welcomed
Richard
Richard
Attachments
First things first, test each module in isolation, preferably on the bench with a separate PSU. Then you can work though and eliminate each component as the source of the problem. However, I suspect an earthing problem, something is not tied to ground properly so voltages are floating.
- Status
- Not open for further replies.