Sorry this is not strictly parts related, but I need some help. I'm building an amplifier using Hypex Nc-400 modules, and they recommend using balanced input. However my output is unbalanced, or RCA, and I'm not entirely sure how to hook up RCA to XLR without introducing distortion. Does anyone know the best way to hook up these 2 things up? Any help is much appreciated, thanks!
This might help, Jensen AN-003. Page 2
http://www.jensen-transformers.com/an/an003.pdf
This might be better in "Line Level" forum actually 🙂
http://www.jensen-transformers.com/an/an003.pdf
This might be better in "Line Level" forum actually 🙂
And you can convert the output of your Source to balanced with the "simple alternative" shown in 2.4
Being a bit of a new person at this and electronics in general, the illustration confuses me a bit.
It involves replacing the output socket (on the preamp say) with a 3 pin socket wired so that the parts in the dashed box are internal to the preamp and connect to the "new" 3rd pin on the "new" socket.
Option 2.1 in that PDF is an even simpler method but less good.
Hmm unfortunately there's no room for method 2.4 because my output source is a computer soundcard and there is no room 🙁
wire the positive output to the positive input and the neutral output (ground) to the negative input. (and if your using a 2 conductor plus shield, wire the sheild to the ground of the input only) Should work perfectly well. edit: just looked at the Jensen page, I have described 2.1
Last edited:
- Status
- Not open for further replies.