I'm not sure what you're trying to clarify in #19. Is it simply that it's a C suffix?
The LMx11 always goes in the location where pins 1 and 4 are directly connected.
Pin 1 of the TL072 is the output but I'd expect it to swing more square. Have you already replaced it?
Is it distorted at a lower output level?
The LMx11 always goes in the location where pins 1 and 4 are directly connected.
Pin 1 of the TL072 is the output but I'd expect it to swing more square. Have you already replaced it?
Is it distorted at a lower output level?
yes, I have replaced it 3 times and I see almost the same wave, at a lower level it does not deform as much
I just replaced it and it works fine I already got a clean sine wave, I just have to try it thank you very much again mr Perry thank you for your valuable support
12v.
Please don't post in a repair thread that was started by someone else unless you are trying to help them.
Start a new thread if you need help with a repair of your own.
If you think this thread is relevant, include a link to it in the original post of your new thread.
Please don't post in a repair thread that was started by someone else unless you are trying to help them.
Start a new thread if you need help with a repair of your own.
If you think this thread is relevant, include a link to it in the original post of your new thread.
Looking through some photos, I did see one board with a 15v Zener but most use 12v. The D1820 board had a 15vZ.
Last edited: