Do you know what the current rating for each of the 39v rails is?
John
Arrround 6-6'5A.
Arrround 6-6'5A.
Are you serious? 2x 38 V x 6 A = 468 W, so 8 x 468 W = 3744 W + the 2x 21 W winding, so more like 4 kW?!?
What kind of amp was this?
It is probably not wise to run this on a single phase of AC as it is borderline even with a 16 A fuse and strong wiring.
By the way, to you have more than one to sell?
Look at the size of the tfmr in comparison to the spade lugs, I'd say it's about 200/300VA tops. That'd mean 1A ish per winding. you can also see the wire gauge, doesn't look anywhere near 6A rated. Lastly I have a 1KVA toroid, it's about a foot in diameter 4" high. Typical 500/600VA toroids are 6" dia 3" high.
Hope that helps any the seller & future buyer gauge current capacity.
Andy.
Hope that helps any the seller & future buyer gauge current capacity.
Andy.
Thanks Andy,
I'm fairly confident it is in fact a 2400VA capable transformer. I think that the two transformers that you can also see in the picture are also for sale here and are confirmed as 1250VA and look a good bit smaller. My offer to the OP reflects any (small) remaining uncertainty I may have. Will check the dimensions before completing purchase though.
John
I'm fairly confident it is in fact a 2400VA capable transformer. I think that the two transformers that you can also see in the picture are also for sale here and are confirmed as 1250VA and look a good bit smaller. My offer to the OP reflects any (small) remaining uncertainty I may have. Will check the dimensions before completing purchase though.
John
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.