Made a couple of these as a development project.
They work very well.
PC USB oscilloscope 23 Million Samples/second single channel.
Time bases { "10uS", "50uS", "250uS", "1mS", "20mS","50mS","250mS" }
Voltage ranges "31mV", "62mV", "125mV", "250mV", "500mV", "1.5V", "1.5V", "1.5V"
Use x10 or x100 scope probe to get much higher voltages.
Single shot and roll display modes.
Analogue and FFT fast fourier transform frequency display.
Positive, negative and no trigger modes.
Save/load traces.
Print traces.
£17-99 plus p+p
p+p is £3-99 to UK and £10-99 to rest of world.
They work very well.
PC USB oscilloscope 23 Million Samples/second single channel.
Time bases { "10uS", "50uS", "250uS", "1mS", "20mS","50mS","250mS" }
Voltage ranges "31mV", "62mV", "125mV", "250mV", "500mV", "1.5V", "1.5V", "1.5V"
Use x10 or x100 scope probe to get much higher voltages.
Single shot and roll display modes.
Analogue and FFT fast fourier transform frequency display.
Positive, negative and no trigger modes.
Save/load traces.
Print traces.
£17-99 plus p+p
p+p is £3-99 to UK and £10-99 to rest of world.
An externally hosted image should be here but it was not working when we last tested it.
Open to sensible offers.
An externally hosted image should be here but it was not working when we last tested it.
Its very easy to hook up, USB lead to PC and BNC to scope probe.
Would recommend a x10 and/or x100 probe.
Comes with a crib sheet for all the function keys.
Regards Nigel
It uses USB HID interface so doesn't need a special USB driver.
Power up pc with it connected and your pc will find it.
Then just run the enclosed pc software.
Click on "display mode" then "Run until escape pressed" and your done.
Regards NIgel
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.