Hi there,
I've been simulating a horn in hornresp and have a problem. Hornresp requires Cms in m/N, but if i do that, i.e. 0.00000182 for the fe166e, the results seem very strange and not what I expected. If I repeat but change it to 0.00182, as if it was asking for mm/N it seems fine, the spl result of which ive shown below. Any thoughts?
Cheers,
Steve
I've been simulating a horn in hornresp and have a problem. Hornresp requires Cms in m/N, but if i do that, i.e. 0.00000182 for the fe166e, the results seem very strange and not what I expected. If I repeat but change it to 0.00182, as if it was asking for mm/N it seems fine, the spl result of which ive shown below. Any thoughts?
Cheers,
Steve
Attachments
Hi;
You can double click on the CMS box and fill in the values that it asks for and then the program calculates CMS. When I tried this with the values for the 166e, I get 0.00182, so I think you are right to use that value.
Hope that helps.
You can double click on the CMS box and fill in the values that it asks for and then the program calculates CMS. When I tried this with the values for the 166e, I get 0.00182, so I think you are right to use that value.
Hope that helps.
- Status
- Not open for further replies.