justblair said:
I am now sending it to whom sent email to me one by one 😀
Please tell me if you have not receive it
Anyone who want one please drop me an e-mail 🙂
Thanks
What sort of power supply is required for this? Is one included in the kit? What is the price for a 4-ch balanced version?
Thanks,
Nate
Thanks,
Nate
n_maher said:
Hi Nate, maybe you need a kit which provides 4 stereo balanced input and one stereo balanced output ?
regards
There are 16 KITs left
bbp said:
Hi Nate, maybe you need a kit which provides 4 stereo balanced input and one stereo balanced output ?
regards
There are 16 KITs left
I've sent several PM to you about my order, but you didn't answer yet.... 🙁
cartman said:
Hi cartman, sorry I didn't got your PM. Please send it again to my bbp6604560(at)hotmail.com.
regards
Lu
Kit received this morning (UK) and looks very good quality! 🙂 🙂
No instructions with it - do you need to email me something?
Thanks
Cliff
No instructions with it - do you need to email me something?
Thanks
Cliff
Hello Lu,
I received the remote control kit this morning, it looks great, nice job!
What's the impedance of the attenuator ?
Regards,
Danny
I received the remote control kit this morning, it looks great, nice job!
What's the impedance of the attenuator ?
Regards,
Danny
cliffforrest said:
danny_66 said:
Hi cliffforrest, thank you for your appriciation, could you send a e-mail to my bbp6604560(at)hotmail.com , maybe my previous 21cn.com email box work bad >_<
Hi Danny, thanks ^_^ The input impedance of the attenuator is 10-40 K and the output impedance is 10K. If you find this attenuator cause too much gain loss in your system, just replace the two 10K resistor with jumpers.
regards
Attachments
cartman said:
Hi cartman, I got your payment for one balanced and one common stereo VOL kit. Thanks ^_^
User Manual received OK.
I really would like a schematic! I find it difficult to work on circuits without one (although this is very simple and all the "smarts" are in the controller firmware 😉 )
Cliff
I really would like a schematic! I find it difficult to work on circuits without one (although this is very simple and all the "smarts" are in the controller firmware 😉 )
Cliff
Got mine yesterday, All seems good, got it powered up
Nice display, love the clicky sounds of the relays.
I haven't connected it to anything yet to try it, I wanted to check that this cable was right before I did.
Its the one that connects the controller to the relay board. Is the twist meant to be in the cables, 4 and 5 (counting from the top of the picture) are swapped. Can either someone who has the kit, or Lu himself tell me if this is right?
Blair
Nice display, love the clicky sounds of the relays.
I haven't connected it to anything yet to try it, I wanted to check that this cable was right before I did.
Its the one that connects the controller to the relay board. Is the twist meant to be in the cables, 4 and 5 (counting from the top of the picture) are swapped. Can either someone who has the kit, or Lu himself tell me if this is right?
Blair
looks like a mistake - no twist in mine!
That's why I would like a schematic!
There must be one, as input to the pcb layout.
That's why I would like a schematic!
There must be one, as input to the pcb layout.
- Status
- Not open for further replies.