As we get to the new DIY kits coming out and thinking of new monstrosities, is it possible (or just dumb) to think of an effiencet way to put a OB xo (B5), ACA or other, and a B1 w/ gain in the same enclosure?
Can I use the same linear ps inside? Would this cause more issues than good.
Thoughts?
P
Can I use the same linear ps inside? Would this cause more issues than good.
Thoughts?
P
There are advantages to separate components.
No reason why you can combine all in one box.
Remember you will need 4 channels of ACAs.
First get all the components before settling on a chassis.
Shoehorning boards into a case after the fact is not fun.
No reason why you can combine all in one box.
Remember you will need 4 channels of ACAs.
First get all the components before settling on a chassis.
Shoehorning boards into a case after the fact is not fun.
you said you were using the B5. It's a 2-way crossover.
Unless you are listening to mono, you will need 4 channels. 😉
Unless you are listening to mono, you will need 4 channels. 😉
ACA is great for mids and tweeters, but will likely fail to power OB woofers.
(I use ACA to power my he1000 v2 headphones, the best headphones amp I heard)
Better use some powerful class AB amp for woofers. Even lm3886 would do.
(I use ACA to power my he1000 v2 headphones, the best headphones amp I heard)
Better use some powerful class AB amp for woofers. Even lm3886 would do.
I'll just use the b5 out to a orca and your right have to use my sub amp I have now for the ob 15s.
- Status
- Not open for further replies.