Faulty tweeter B&W DM601

Status
Not open for further replies.
Hi everybody,

I come to you because i'v got a problem duh...
I just bought a pair of BW 601, i'm really a newbie on audio, i decided to install a 5.1 (TR NX474, LCR60 and 2 603 S3 in front,and 2 601 in the back).

And it seems that one of the tweeter doenst work.
what part would be in cause ?

Thank you very much for your help,I am really saddened, this last purchase was supposed to complete my entire setup.
 
It is most likely that the tweeter itself is faulty. To see if this is the case you can swap the non-working tweeter with the working one in the other cabinet.

If the fault crosses over to the other cabinet then the tweeter is faulty. This YouTube video shows how to remove the tweeter.

YouTube
 
Hello Galou, to finish I took everything apart measured the resistance of my tweeter (=Overloaded), I took apart the tweeter and noticed that the two wires of the voice coil was cut, I reconnected it with two strands of copper. unfortunately I did it a little like a wild one (no soldering iron, just a lighter). But it works, and thanks to this forum that has given me the energy to do this repair, I think now I will try to improve them, I have seen here, polymer history etc....
 
+1 for Galu, a wise man 🙂
I'm going to start with that, because I don't really want to start dismantling my 603 and LCR60. and the 601s are just for the rear (they're a little big, but it's a start) so maybe for now there's no need to improve.
 
Status
Not open for further replies.