• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Fastron Inductor Group Buy for JG Filter Buffer

Status
Not open for further replies.
OK,

So after a marathon session, the kits are all packed and pretty much ready to go. I will probably post them on Saturday all going well...... Transit to most places is 7-10 days after that hopefully.

I'll update again when I post them all out.

For anyone on the waiting list, kits are in very short supply. Jean-Paul - I have one for you assuming all others are delivered OK. Due to the fact that I had a good few non-perfect inductor matches, I don't have sets of these either. I do have a few matched pairs, but they are measuring down at 13 to 10mH. Maybe you can compensate for this by varying a resistor. If someone wants some of these let me know.



Fran
 
My kits and inductors arrived today 🙂
Two questions though:
1: Are the 18K7 resistors in the package the ones that aren't labelled?
2: Is there somewhere an image or something that shows where to put what on the board?

Regards
 
I can take #1

Yes the unmarked resistors are the 18.7k ones and importantly, you only have 2 of them, whereas you have extra of all the other SMD components. So solder the others first and then when your skills are up, do the 18.7k.


Do please post here when the packet arrives and I'll update the spreadsheet.


Fran
 
Status
Not open for further replies.