I don't know.
I put forward an argument based on what I understand the diode brings to the equation.
I will listen to other argument/s and comment where I think I can bring further useful information to the table.
I note that Pass have not come in to comment one way or the other on the intended way that the diode should operate. I wonder why?
I put forward an argument based on what I understand the diode brings to the equation.
I will listen to other argument/s and comment where I think I can bring further useful information to the table.
I note that Pass have not come in to comment one way or the other on the intended way that the diode should operate. I wonder why?
F5T Boards
What are the dimensions of new output boards?
Will the singles still be available? or how do we cut these boards and still make something short of a mess?
What are the dimensions of new output boards?
Will the singles still be available? or how do we cut these boards and still make something short of a mess?
Does that rolling about bursting a gut, imply you like the way we are getting ready to tie ourselves in knots and the Lord is just waiting in the wings to gather up the pieces and forgive us for doubting his wisdom?
Andrew is.....NEWMAN!
Favorite Costanza quote:
"If everything thing I say is wrong, The opposite must be right!"
This is hitting a little too close to home for me
Favorite Costanza quote:
"If everything thing I say is wrong, The opposite must be right!"
This is hitting a little too close to home for me
Last edited:
Hello all,
First off just want to apologize. I somehow completely missed the few posts after my last about PSU diode heatsink temps. The discussion has obviously evolved several subjects since then.
So, I have input jets with an Idss of 7.1mA Should I go ahead and make the component changes to accommodate the lower values? Or, should I use the default values and see if I run into issues.
If yes to new components- I have read of changing R3,R4 to a lower value or changing P1,P2 to 10k.
Is one method better than the other?
First off just want to apologize. I somehow completely missed the few posts after my last about PSU diode heatsink temps. The discussion has obviously evolved several subjects since then.
So, I have input jets with an Idss of 7.1mA Should I go ahead and make the component changes to accommodate the lower values? Or, should I use the default values and see if I run into issues.
If yes to new components- I have read of changing R3,R4 to a lower value or changing P1,P2 to 10k.
Is one method better than the other?
See if you run into trouble. My guess is you will have max Vgs of about 3-3.5V. You could p arallel another 10r across current one and remeasure and see what that gets you. Just tak eth eoppportunity to play, experiment and learn. We will all be here to laugh at you and help you. If it gets bad, i hav eplenty of sad buildin gstories to cheer you up. Just yesterday i blew up a resistor. Quite impressiv ereally. Who would have thought you needed glasses for this sort of thing🙂
- Status
- Not open for further replies.