• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

DCB1 Black, White and Red Kits

Jump to Latest
#45
Kit

T-B,

Just received my kit yesterday and everything looks great and thanks for the TO-247 pads. Nice work 😀

I went full boat on I/O resistors: Caddocks, TX bulk foil, ect. Current wise, I'm going to go right to 3.3R.

Thanks,

Greg
 
#53
AndrewT said:
Why do we have to go to Audiocircle to find the "best" assembly instructions?

What was Wushuliu thinking about?
Click to expand...

To spread the word and encourage people who are not as familiar with the possibilities of DIY. Also, it's an easier forum to edit posts with fewer tangential distractions. What can I say, I'm a forum butterfly.

I didn't know full kits were being offered. Must resist!:bawling:
 
#59
Yes I believe it does.
The cathode should go towards squared off part of the symbol drawn on the board.
The LEDS in general are ~1.8-2.0v tested. I would measure up as many as you can to add similar pairs to each side. so the sum total for each set of 5 matches up, then same for the 3 leds.
 
You must log in or register to reply here.
Top Bottom