?? Not familiar with this, which requires a near enough (>10x Vas) IB for a 0.4 Qts' driver to get 'close enough' to a 0.4 Qtc. A 0.4 Qts' driver OTOH is for a classic reflex alignment where Vb = Vas, Fb = Fs.
(Qts'): (Qts) + any added series resistance (Rs): http://www.mh-audio.nl/Calculators/newqts.html
Does the driver really have 7000g mms, a 15 pound cone? I know about the imperial metric problems in Northern America.
1.7 litre Vas is very little and quite unusual, too. Maybe check if you did not convert from square foot?
This is what I saw in 5 seconds. Maybe check all the input for the right units and decimal places?
1.7 litre Vas is very little and quite unusual, too. Maybe check if you did not convert from square foot?
This is what I saw in 5 seconds. Maybe check all the input for the right units and decimal places?
Last edited:
I tried with the data, and get a good file with no integrity errors at all. But you need to follow the order like is instructed in the WinISD treat. The file i made is attached.
