Dayton DMA-90 3.5 inch alu cone

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
This unit is now available:
Dayton_DMA90-4_(Photo_1).jpg

Dayton_DMA90-4_(Photo_2).jpg

Dayton_DMA90-4_(Frequency_response).png


Resonant frequency Fs 88.2 Hz
Surface of the diaphragm Sd 38.5 cm²
Effective diaphragm diameter Ø 7 cm
DC resistance Re 3.8 Ω
Mechanical Q Qms 2.50
Electrical Q Qes 0.56
Total Q factor Qts 0.45
Efficiency bandwidth product EBP 157
Suspension equivalent air volume Vas 2.265 litres
Suspension mechanical compliance Cms 1030 µm/N
Moving mass Mmd 3.1 g
Moving mass (including airload) Mms 3.2 g
Mechanical resistance Rms 0.7 N·s/m
Force factor BL 3.5 T·m
Voice coil inductance Le 0.3 mH
Maximum linear excursion Xmax ± 2.5 mm
Displacement volume at Xmax Vd 9.6 cm³
Efficiency η₀ 0.27 %
Dayton Audio DMA90 - 3.5" Full-range
8 ohm version available too

Does anybody have any other measurements on this driver?
I'm probably going to end up buying and measuring it anyway, it's dirt cheap.

Thoughts?
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.