Yes, QRV is perfect.
I wanted to clear up measure and to bring in on discussion author´s measures.
Regards,
Bohdan
I wanted to clear up measure and to bring in on discussion author´s measures.
Regards,
Bohdan
I think we can make the conclusion that my current feedback design has extremely low distortion and by listning tests my new QRV-08 with super regulators may be the best headphone amp in the world. 
I´ll interpret Ladislav Bunta´s words :
RMAA measurring is provided at level higher than 1V RMS (cca –3dBFS). In this case the distortion of analoque circuits (pre A/D and post D/A conversion) is higher. In addition RMAA measurring is THD + N, so there is also signal nois. RMAA probably uses smaller amount of samples and higher sampling frequency.
ST measuring (THD = 0,000 04%) is provided in mode Out/In whith fs = 22.050Hz, 24 Bit and FFT = 131.072. If I am interested in THD at 1kHz, I have no reason measure with e.g. 96kHz. Measurement into 10-thneeded harmonic is sufficient. Futhermore it is by Uout 1V RMS, where Lynx L22 has analoque circuits Out & In the lowest distortion.The change level +/-0,1 V suffice for degradation result of measure . In order to every sound card is needed verify optimal level for In and Out. Then it is needed to move on that level. E.g. with help of external attenators.
This is explanation of the measuring results.
RMAA measurring is provided at level higher than 1V RMS (cca –3dBFS). In this case the distortion of analoque circuits (pre A/D and post D/A conversion) is higher. In addition RMAA measurring is THD + N, so there is also signal nois. RMAA probably uses smaller amount of samples and higher sampling frequency.
ST measuring (THD = 0,000 04%) is provided in mode Out/In whith fs = 22.050Hz, 24 Bit and FFT = 131.072. If I am interested in THD at 1kHz, I have no reason measure with e.g. 96kHz. Measurement into 10-thneeded harmonic is sufficient. Futhermore it is by Uout 1V RMS, where Lynx L22 has analoque circuits Out & In the lowest distortion.The change level +/-0,1 V suffice for degradation result of measure . In order to every sound card is needed verify optimal level for In and Out. Then it is needed to move on that level. E.g. with help of external attenators.
This is explanation of the measuring results.
Have you had any opportunity to intense listening yet?
"Current feedback not suitable for audio?" as a thread here was called, according to me it is _very_ suitable for audio. 🙂
Super regulators feeding current feddback amp is an excellent combination.
"Current feedback not suitable for audio?" as a thread here was called, according to me it is _very_ suitable for audio. 🙂
Super regulators feeding current feddback amp is an excellent combination.
- Status
- Not open for further replies.