No, just on the servo board, but that's what I'll try next.Has the PSU had a recap as that is where suspicion might lie.
I might have to clean up after that, following this thread.
This thread also gives me hope.
That's an old thread of mine 🙂
I would definitely look at the PSU before trying anything else.
I would definitely look at the PSU before trying anything else.
"+5VCD" and "+9V_motor" go to the servo board. Voltages are stable, but on pin 9V_motor there is 9.9V. Is there a problem with that?
The caps in the main board power supply look good.
The caps in the main board power supply look good.
You would have to study the circuit but as far as voltage goes I doubt there is a problem. It may not be tightly regulated to an exact value.
- Home
- Source & Line
- Digital Source
- CD player reads CD-Rs, but not CDs