Member
Joined 2002
Where is a good place to buy caps for powe supplies..
like 10,000mf and up @ 75volts and small imlooking for small ones..
not the coke can type..
jason
any one help me
Prefurabley in canada..
like 10,000mf and up @ 75volts and small imlooking for small ones..
not the coke can type..
jason
any one help me
Prefurabley in canada..
>50V starts getting tough surplus but they do exist. Check your favorite shops, and check out Ebay...I've seen good deals before there.
There is a list of some surplus dealers on my site. I don't think any of them have large value caps at 75V but I haven't looked recently. All are in USA unfortunately, but the cost of shipping is far less than the savings off of 'retail'.
http://www.anidian.com/
There is a list of some surplus dealers on my site. I don't think any of them have large value caps at 75V but I haven't looked recently. All are in USA unfortunately, but the cost of shipping is far less than the savings off of 'retail'.
http://www.anidian.com/
Capacitors
Just to let you and this forum know that I now have in stock
PHILLIPS part # 3186EE263UO75HPA2
26,000MFD 75 Volt with a 95V Surge 9235 date code
measure 2" X 4 1/8" snap in type with 3 leads on top
positive- negative and a locating lead
They are new and priced at $6.95ea
Just In and not listed on my website yet
Thanks
Steve
Apex Jr
steve.apexjr@prodigy.net
www.apexjr.com
Just to let you and this forum know that I now have in stock
PHILLIPS part # 3186EE263UO75HPA2
26,000MFD 75 Volt with a 95V Surge 9235 date code
measure 2" X 4 1/8" snap in type with 3 leads on top
positive- negative and a locating lead
They are new and priced at $6.95ea
Just In and not listed on my website yet
Thanks
Steve
Apex Jr
steve.apexjr@prodigy.net
www.apexjr.com
The locating pins are there so the positive and negative
pins are placed in the right PC holes.
BTW ......leads are 1/2" long
The reason I mentioned them is that they are not the screw
terminal type.
Steve
pins are placed in the right PC holes.
BTW ......leads are 1/2" long
The reason I mentioned them is that they are not the screw
terminal type.
Steve
I wish you had had those when I placed my last order Steve. Already soldered everything to the bus bar, so its all there for good. 😉
- Status
- Not open for further replies.