Building a battery compartment

Status
Not open for further replies.
I'm building a headphone amp, but I'd like to build in a battery compartment so I don't need to open up the entire casing each time I have to replace the battery. I've searched for a battery holder with cover, but haven't been able to find one anywhere.

Any tips on constructing a battery compartment?
 
NiMH or Nicad batteries are dead easy to use... one resistor and a supply (charger) higher than the battery voltage is all that's needed. If your using PP3 and AA then thats two resistors 😉

That assumes the batteries are "disconnected" when the H/phone amp is switched off.
 
Rose & Bopla:
 

Attachments

  • battery.JPG
    battery.JPG
    2.9 KB · Views: 100
Status
Not open for further replies.