Buffalo 3 not working in Stereo mode

[gwikse]

It is pin 3 (output), not pin 2 (gnd).

It gets confusing as we dont seem to have our pictures aligned the same on all of them.

I take it that there should not be 5V on pin3 either?

An externally hosted image should be here but it was not working when we last tested it.

 

[pellesmil]

Thanx Brian.

Will try to feed the dead B3 with a fresh 100Mhz clock signal from a working B3
If it plays tango am up for a new Crystec (and a fresh Firmware...)

P.

 

[BrianDonegan]

Definitely confirm there is not 5v at that pin first though.

 

[pellesmil]

X-files....

 

[BrianDonegan]

Any results?

 

[pellesmil]

Need to pick is up and diagnose quite soon.
Getting final here is on the schedule

 

[gwikse]

Let me know if you need any help. I live in Oslo and have a lot of tpa modules and stuff to test with 😉

PS. PM @ HFS if need be DS.