I tried to solder with tin but it does not work.. Do you know how can I fix it ?
Can you fix the photos?
Your images dont show for me either and simply return a:
Just try attaching them to the forum. It takes seconds to do:
How to attach images to your posts.
Error 404: Server couldn't parse the ?url= that you were looking for, error it got: Invalid or unsupported image format. Is it a valid image?
Just try attaching them to the forum. It takes seconds to do:
How to attach images to your posts.
Using a sharp blade (x-acto type knife) scrape off some of that black stuff to expose a little bit more of the voice coil wire next to the break."What can I use to do this?"
Next gently scrape the enamel off that section of voice coil wire.
This should expose enough copper for you to strengthen the repair by soldering a suitably sized strand of copper wire across the break.
Did you miss the photos Moondog?
No I just cannot see a break in the VC wiring so I echo what turk 182 said. Could be my eyes or an unclear photo tho
Sorry if I'm getting it wrong Moondog, but it appears to me that the OP has been attempting to solder where the voice coil wire is crossing over to the upper, rectangular solder pad.
I am seeing a lumpy, uneven solder residue there and some melted 'wax'. Hope the OP will clarify soon.
I am seeing a lumpy, uneven solder residue there and some melted 'wax'. Hope the OP will clarify soon.
i looked at it again on a larger higher rez monitor and the bottom pad has an oval approaching the edges of the square pad, the upper one i see an oval that is much smaller in diameter.
are the tinsel leads on the topside of the cone or is that what's up with the double row of silicone globs on the spider is that where the tinsel leads where attached?
was continuity checked with a meter? being a car audio sub with long excursion all soldering must not create a raised point or build up that could wind up getting caught in the gap.
are the tinsel leads on the topside of the cone or is that what's up with the double row of silicone globs on the spider is that where the tinsel leads where attached?
was continuity checked with a meter? being a car audio sub with long excursion all soldering must not create a raised point or build up that could wind up getting caught in the gap.
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Loudspeakers
- Multi-Way
- Broken wire on a coil, any way to fix it ?