ok, mainly can i bend the leads for the lm3886 and lm3875 chips? i have large plate like heatsinks and would like the PCB to be parrelel to the plates, so the tabs would have to be parellel as well. i figured this would be a good solution, but since manythings i try don't work, i figured i may as well ask!
thylantyr said:[snip]I think people where the garlic
when I post.
[snip]
Well, to be honest, if I saw a post like this I wouldn't know what to answer for the life of me.
Jan Didden
I think people here are more conservative at giving opinions,
perhaps they fear being roasted
The other forums are kinda fun,
where people want to reply no
matter how silly the response
inviting more debate
.. or ...
People don't want to be bothered
with silly questions
I would say 90% (+/- 50%) of the time
I know the answer but want
to verify to get my thoughts
at 100%.......
oh well.
Time to move to audioasylum's
cable forum........
perhaps they fear being roasted
The other forums are kinda fun,
where people want to reply no
matter how silly the response
inviting more debate
.. or ...
People don't want to be bothered
with silly questions
I would say 90% (+/- 50%) of the time
I know the answer but want
to verify to get my thoughts
at 100%.......
oh well.
Time to move to audioasylum's
cable forum........
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Solid State
- bending leads