Hi,
what is this supposed to do?
Why two cascaded stages?
What happens when the first stage gain is set >1?
How did you set the first stage gain=1?
Why only 12Vdc supply?
What is the maximum signal that can pass through these opamps?
what is this supposed to do?
Why two cascaded stages?
What happens when the first stage gain is set >1?
How did you set the first stage gain=1?
Why only 12Vdc supply?
What is the maximum signal that can pass through these opamps?
Hi
what is this supposed to do?
-- > using preamp for mini sub
Why two cascaded stages?
--> Prior to this I was using single amp But I did not get good effects.
Why only 12Vdc supply?
--> I am using 15Vdc supply.
I do this all for my hobby. I am not an electronics man.
how this preamp works ? I don't know but It's sounding good for me. In general term I used Dual POT/CONTROL which has 6 pins as shows in attached picture.
what is this supposed to do?
-- > using preamp for mini sub
Why two cascaded stages?
--> Prior to this I was using single amp But I did not get good effects.
Why only 12Vdc supply?
--> I am using 15Vdc supply.
I do this all for my hobby. I am not an electronics man.
how this preamp works ? I don't know but It's sounding good for me. In general term I used Dual POT/CONTROL which has 6 pins as shows in attached picture.
Attachments
- Status
- Not open for further replies.