Bad enclosure design or crappy driver?

Status
Not open for further replies.
Jump to Latest
#41
Here photos
Is it very important that braces to be glued to both sides because it is not tight when placing the sheet to subwoofer ? There is a space between pieces and side of sub
 

Attachments

  • 20140907_160152.jpg
    20140907_160152.jpg
    336.7 KB · Views: 75
  • 20140907_160144.jpg
    20140907_160144.jpg
    313.7 KB · Views: 74
#43
Sorry for my bad English. I meant braces are glued on one panel but sometimes they do not contact well to other sides left and right.There is one or two mm blanks somewhere..Is it very critical for vibrations and sound.I am talking about 2. Picture.
And i will first build the schleton after that will glue outside panels in future
Thanks
 
#44
Glue alone when using a small interface surface area will not carry sufficient tension.

Either the glued joint will fail or the ply to ply bond will fail in tension.

You must find a way to secure the bracing to the panels, such that the junction can carry both compression AND tension.
 
Status
Not open for further replies.
Top Bottom