Article - Sony VFETs part 1

Status
Not open for further replies.
I believe that Permender used the schematic from the NP article for the CX1:

http://www.firstwatt.com/pdf/art_sony_vfet_pt1.pdf

I have looked at the board carefully, and it looks to be the exact circuit, including the buffer for single ended input.

I have a question for the panel : I am planning a dual mono amp with the PSUs in a separate case. The main PSU will be directly from the VFET article. Permenders boards take the AC from the bias transformer directly. Could I use a bridge rectifier in the PSU case, so as not to pass AC current from PSU to the amp case? Are there suggestions to do this in a working manner. Or is this low voltage AC just not worth stressing over? I have not arranged the cases, nor purchased power connectors.
 
also known as Mithrandir

or , in Elvish : Poor ZM's Peanut Brain Melter

:clown:
 

Attachments

  • Mithrandir.jpg
    Mithrandir.jpg
    51.7 KB · Views: 466
Status
Not open for further replies.