I like the idea of monoblocks, so that is what I am planning on building. You can make them smaller than Stereo units. I have standardized on the 330 x 300 footprint sized chassis. Power supplies are in separate enclosures. Since I have two heatsinks I am building M2X/F6 monoblocks. Can use either amp module or both.
Well, if the chassis had the width of the distance between the speakers, all would be well, soul saved, speaker wires short [emoji1]
But, silly comments aside, what about bridged or parallel modes?
My opinion is that if two cases are an option, then for something, uhm, really different/promising.
Last edited:
With 2 separate chasses, you could site each amp right next to its speaker, which eliminates the long speaker wires. It's easy to send the signal to the amps because of the low power involved in a line level signal.
Oh yes, short speaker-cables, but long signal-cables...
If one was to make the monos to retain all those relatively big or small advantages, should he not also go the balanced way for that last bit of precision?
If one was to make the monos to retain all those relatively big or small advantages, should he not also go the balanced way for that last bit of precision?
I have no need for monoblocks personally as run active speakers so two stereo amps and short cables.
I wouldn't say balanced interconnects give you precision, but I have them as I can.