Deeply appreciate if anyone can share circuit for akm4396, i have no idea how to set up the pin 8-14 of akm4396.😱
http://www.asahi-kasei.co.jp/akm/en/product/ak4396/akd4396-sbw2-02e.pdf
evaluation board menu.
you can find circuit there.
evaluation board menu.
you can find circuit there.
Thanks for your reply. Here is my few attempts after reading data sheets. I wan the circuit as simple as possible to minimize all parts.
An externally hosted image should be here but it was not working when we last tested it.
I am very confuse for pin 4 and pin 8 to 14 especially for pin 9😕
By referring to the datasheets.
An externally hosted image should be here but it was not working when we last tested it.
*I set my DEM0 : DEM1 to 1:0 for default
*Smute to Low
An externally hosted image should be here but it was not working when we last tested it.
*DIF2 : DIF1 : DIF0 to 0 : 1 : 1 for IIS mode.
And i am not quite sure about the reset pin.. I am running this off from pcm2707. Please guide me if i did wrong😱
Last edited:
- Status
- Not open for further replies.