appreciate if anyone can share circuit for akm4396?

Thanks for your reply. Here is my few attempts after reading data sheets. I wan the circuit as simple as possible to minimize all parts.

I am very confuse for pin 4 and pin 8 to 14 especially for pin 9:confused:

By referring to the datasheets.
*I set my DEM0 : DEM1 to 1:0 for default
*Smute to Low

*DIF2 : DIF1 : DIF0 to 0 : 1 : 1 for IIS mode.

And i am not quite sure about the reset pin.. I am running this off from pcm2707. Please guide me if i did wrong:eek:
Last edited: