Nice work 🙂 I've got m26's in my 3ways too, nice drivers....
what are your crossover points?? The M26 is supposed to be crossed lower than 500 Hz for optimal performance, but I'd say you couldn't go that low with the dome mid (I have phillips dome mids, crossed at 500 Hz which is too low)
edit: actually I'd like to know box volume and tuning freq too 🙂
anyway enjoy 🙂
Tony.
what are your crossover points?? The M26 is supposed to be crossed lower than 500 Hz for optimal performance, but I'd say you couldn't go that low with the dome mid (I have phillips dome mids, crossed at 500 Hz which is too low)
edit: actually I'd like to know box volume and tuning freq too 🙂
anyway enjoy 🙂
Tony.
Tony,
I had to cross at 900 because of the high Fs of the mid. However, I used a third order all pass filter on the low pass, and also a third order on the band and hp. I added impedance compensation and a 4 db BSC. The most complicated xo I've done, but I think it turned out pretty well.
Hong
I had to cross at 900 because of the high Fs of the mid. However, I used a third order all pass filter on the low pass, and also a third order on the band and hp. I added impedance compensation and a 4 db BSC. The most complicated xo I've done, but I think it turned out pretty well.
Hong
Your imaging must be fantastic given the center-center distance of your mids and tweets. Nice work sir!
- Status
- Not open for further replies.