Does anyone have info on bias setting for the adcom 5800? I have done a THRESHOLD s/200 with good results.
is this the SE or just standard? here is a link to tell you how to do it I am guessing you had to change the 220 uf caps and clean boards, I just did it on a 585 SE bias was fine did not have to mess with it at all. I will give ya the link
http://www.diyaudio.com/forums/solid-state/90059-speakers-adcom-gfa-585-a.html
http://www.diyaudio.com/forums/solid-state/90059-speakers-adcom-gfa-585-a.html
Last edited:
sorry you have 5800 my bad lol but still basically the same you need a dummy load just read the link
you should be able to do it the same as 585, read the thread,use a dummy load, -18 mv I think is what the thread said, I might be wrong, try it just do not hook speakers up till you know it's good, if you have a scope, scope it before you hook speakers to it
Last edited:
- Status
- Not open for further replies.