Active tube preamp with TDA7492 ?

[Wieslaw Lipowsk]

Can I use my 6SL7 SRPP active preamp with TDA7492? I use such a pre now to feed my Dyna Mk III as their sensitivity is very low (about 1,2 V with the Poseidon upgrade).
I hear I cannot use any active pre with TDA7492. However, the signal from my NOS DAC is very low, with the Dyna I have to turn the volume almost full as my speakers are just of 84dB sensivity.
If I am careful with the this pre can I hope nothing really bad will happen?
I'd be grateful for some good advice.
Wieslaw

 

[nigelwright7557]

Should be ok.

I sometimes add valve pre amps front ends to power amplifiers.

 

[Wieslaw Lipowsk]

Thanks. I have found my TDA7492 based Sure D-amp does need a pre although the manual says it does not.

 

[TheLoon]

Have you tried a tube preamp with your sure TDA7492 amp? If so any problems?

 

[Wieslaw Lipowsk]

Yes, I have. I had no problems with it. Now I use a TDA7498, though.