Im working on a a/d/s pq20 amp i repaired the power supply in it but there is 2 yellow thermisters in the circuit without them the amp dose nothing i measured them with my multimeter and it reads 0.38 ohms when cold wondering if anyone knows what i can replace them with and were i can get them any help would be appericated thanks
I have never seen these broken. Perhaps if the wires are broken at the yellow body you can shave the coating back ans solder flexible wires to the wire stubs and then place the device back in service.
Due to age I know of no source for these, perhaps if you could find a PQ-15 or 20 thats just parts then maybe spares could be had....Good luck🙂
Due to age I know of no source for these, perhaps if you could find a PQ-15 or 20 thats just parts then maybe spares could be had....Good luck🙂
wellthey are missing when i bought the amp someone took them out wondering if i can put anything in its place to make the amp work snice i have no clue what value they are
Can you get your hands on a PQ-15 < they are just about the same power supply wise. Then you could remove and measure the temp sensors at 25 degrees C and take a shot at replacing them.
Anyone here got a ADS schematic diagram floating around???
Anyone here got a ADS schematic diagram floating around???
- Status
- Not open for further replies.