• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

6L6 / EL34 / EL84 / 6V6 frequency response curves?

Status
Not open for further replies.
Jump to Latest
#101
teemuk said:
This. I read between the lines the spectrum plots are taken from speaker terminals of a 1W amplifier. That's a complete system where several different variables could affect the test results and setup.

For example, the loading characteristics most likely are not purely resistive and may change at different frequencies. Within tube parameter spread one tube might handle it differently than another. This would undoubtedly create a different spectra.
Click to expand...

I dont think the driver tube sees the speaker load....

It wasnt a 1w amplifier, just measurements😀
I couldnt find my 8 ohm dummyload, and 1w 1 kHz was all I could bear. Also I wanted to see if the speakers uneven impedance curve had any influence on the frequency band.

It is a 15 w triode push pull el34 amplifier.
 
Status
Not open for further replies.
Top Bottom