I also use a Mac and I've been using the drawing portion of the ancient AppleWorks program to draw schematics. But it is only supported on very old Macs and I have an ancient Mac Mini devoted to its use. It would be nice to be able to use my slightly less ancient Macs for this purpose.
I followed the link but didn't see a drawing program. Could you provide a more specific link? Is it downloadable or online? Any chance you'd be willing to share your symbol library?
Perhaps a new thread on the subject would be in order as this one seems to have veered off course already. Or send me a PM.
I followed the link but didn't see a drawing program. Could you provide a more specific link? Is it downloadable or online? Any chance you'd be willing to share your symbol library?
Perhaps a new thread on the subject would be in order as this one seems to have veered off course already. Or send me a PM.
Last edited by a moderator:
BTW, here's a link to Dave Gillespie's thread about his mod for the little Magnavox SE 6BQ5 amp. If anyone has questions about the design he will likely answer if you post there.
https://www.audiokarma.org/forums/i...ore-out-of-the-8600-series-a-lot-more.665735/
https://www.audiokarma.org/forums/i...ore-out-of-the-8600-series-a-lot-more.665735/
Wrong URL. https://www.vectorworks.net/en-CA
I guess there are 2 different VectorWorks.
Note that the software is not cheap.
My symbol library is really a set of groups, spread out across a zillion drawings. It would take considerable time to gather them all together.
dave
Note that the EL84/6BQ5 is operated exactly according to the datasheet. Hence, I don't see to get the circuit complicated by featuring a bias adjust potentiometer. Just provide a cathode resistor of 135 Ω ( 2 x 270 Ω in ||), that's enough.
Best regards!
Best regards!
