Done and working second b500 felling happy 🙂
Sent from my GT-S7562 using Tapatalk
An externally hosted image should be here but it was not working when we last tested it.
Sent from my GT-S7562 using Tapatalk
To apex thank you for your amp it sound crystal clear and with power thank you thank you and merry christmass
Sent from my GT-S7562 using Tapatalk
Sent from my GT-S7562 using Tapatalk
Can you post the shematic you followed using darlington.... Also posting some pictures of your work would make some friends easier to help.
Ok my friend i will post some pic later. For my darlington configuration i use mr.mile darlington scheme he sugess on this forum.
i use 1k instead 680R and 220R instead 330R for biasing darlington config. Its normal ?
hi apex audio
thanks for sharing.
I try to make a layout for this B600, need some check for error
thanks for sharing.
I try to make a layout for this B600, need some check for error
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
Last edited:
i think because of your box speaker design. Prevent a 90 degre of all your corner inside your box. Its to prevent canceling.
hai mr.syahrul can u tell me, why left and right have a defferent dc offset.? What can cause that?
Nice design mr. Syahrul. I asked permission to make power B600 with your design.. By the way, your image file is too large, perhaps in pdf format can be more effective. Regard. 🙂
Last edited:
Last edited:
hi apex audio in schematic B600, on the negative rail right MJE350 Did not MJE340 so what? ... I followed the test scheme MJE350 wearing burnt R100 oh please its pencernahan
On negative rail must be MJE340, it's notification error on schematic is NPN transistor.