Change the Vbe to bd140 to get the trimmer on the safe/correct side. And swap the 560r 1k to get a suitable voltage.
What is the effective gain of the opamp when it is inside the global feedback loop?
Add decoupling to the supply rails and at the output devices.
How did you arrive at the 120r feeding the drivers? Is 5mA a good bias current?
What is the effective gain of the opamp when it is inside the global feedback loop?
Add decoupling to the supply rails and at the output devices.
How did you arrive at the 120r feeding the drivers? Is 5mA a good bias current?
Hi Gost22
Unsure if this has been corrected, but output of TL071 or NE5534 is on Pin 6, your schematic shows as Pin 1.
Cheers / Chris
- Status
- Not open for further replies.