Yes 2x4 turns but not in opposite windig. Just 4 turns with double wire and connect first from one to the last of second coil for central tap (gnd).
And onother for aux +/-15v.....many coils difficult winding...
I can't see any protection circuit.
First step is to identify the cost.If isn't near the commercial one, maybe i will give a try.
Is this a tested or a beta version?😉
Last edited:
here is a final version of APEX regulated PSU made fine tuned with transformer snubbers and the premium wago 256-402 connectors for the o/p. The layout is single sided and can be etched at home. Or can be produced at boardhouse as a 2 sided layout.
regards
Prasi
regards
Prasi
Attachments
Last edited:
Good work Prasi!
Q1 and Q3 types swapped around ? but that should be obvious to any builder.
Attachments
Wouldn't zener diodes of 5.6 or 6.2 volts (and appropriate output votage dividers) preferable, due to their better tempco?
Best regards!
Best regards!
Well, it depends on the desired output voltage. Für roughly the same voltages as in the original schematics (which aren't given, though...) either increase R3 and R10 to 33k or decrease VR1 and VR 2 to 470 ohms and R4 and R6 to 680 ohms.
Best regards!
Best regards!
Erm, I'm wondering: The thread is about single supply amps with output capacitors. All of a sudden, we're discussing split supply PSU's now?
Best regards!
Best regards!
Business as usual, I'd say. Threads started by Apexaudio show a strong tendency to derail after a while.
Best regards!
Best regards!