And what did we buy today?

Fluke 8000a with low ohms and battery options.
I like the retro LEDs , styling very sleek.
Its amazing checks out perfect on calibrator.
$9.00 plus sales tax so under $10.
 

Attachments

  • F8ACE9DD-BB85-460F-8A23-AB1AF82AED73.jpeg
    F8ACE9DD-BB85-460F-8A23-AB1AF82AED73.jpeg
    868.8 KB · Views: 206
A pair of NOS inductors...

I'm your typical male. I think all you of people driving around faster and more aggressive than ever are NUTS. You're weak. You're fearful people whose only response to stress is to impose your will on others.

There. I said it.
 
Replacement Samsung Galaxy S5 cell phone. Busted the screen cover on my current one. $200 for a glass replacement, or $190 for a phone. Decisions, decisions.

I may buy a replacement kit for the screen cover and try to replace it myself.
 
I bought a Ryobi ONE+ 1/2" impact wrench:
RYOBI 18V ONE+ Cordless 3 Speed Impact Wrench Kit | Bunnings Warehouse

Truly amazing tool and amazing battery system the ONE+ system is.

HIGHLY praised and HIGHLY recommended! I can now take a tyre off my car, a brake caliper, in under 10 minutes and reassemble it all in the same amount of time. Even the car screw jack has a 18mm nut on it that I can use the cordless wrench with! The car jacks up in less than 30 seconds!
 

Attachments

  • 103-diyaudio.jpg
    103-diyaudio.jpg
    329.7 KB · Views: 194
Last edited:
And yesterday/today:

USB to serial TTL adapter:
FT232RL 3.3V 5.5V FTDI USB to TTL Serial Adapter Module for Arduino Mini Port | eBay

Looks like tons of features for $2 and many uses. I bought it thinking I could get my Atari 8bit setup running again at the new house (no, I'm no relation to Dude111).

USB to IDE adapter:
USB 2.0 to IDE SATA 2.5 3.5 Hard Drive HD HDD Converter Adapter Cable Useful | eBay

I'm hoping this will allow me to archive anything remotely useful that I have on my old IDE HD's much quicker and with finality. I hope it works for $3. I am skeptical of all the cheap Chinese "adapters" on eBay since I bought at least 3 IDE to SATA adapters a while back that I finally realized were just PCB jewelry.
 
Was this close to ordering this big stupid plastic dingus (called a "carrier") that broke on my ancient garage door opener. But instead, after staring at the broken pieces for awhile like Nipper the RCA dog, I think I figured out how to fix it with a length of PVC half-pipe and a pair of hose clamps. So far, so good. The acid test will be later in the season, when the door freezes to the concrete pad. Something's gotta give...