If input was overloaded that produce DC on zeners for limiter (C2)
0.22R equalise current from unmached mosfets
With BD139 on heatsink you can run amplifier in class AB
Not nessesery to bypass zener
There is Zobel network on output but RC shunt.
Regards
Hi Apexaudio,
I have tried to print the thumbnail attachment of your pcb but it would not print the correct size. May I request to have it in a pdf file if you have time to spare.
and thanks for all your great contributions to the DIY community.
Regards,
I have tried to print the thumbnail attachment of your pcb but it would not print the correct size. May I request to have it in a pdf file if you have time to spare.
and thanks for all your great contributions to the DIY community.
Regards,
Good point! Do you still need R1 and C1 ?
I like the C14 and C16 bypass, you may think of bypassing C2 and C6
Otherwise looks fairly clean, I'd be tempted to increase local feedback and decrease global NFB next, although your GNFB goes through less stages than some!
For home aplication R1,R2,C1,D1,D2 can be removed, and BD139 put on heatsink for AB setup. Bias can adjust with variable resistans of R22. With AB setup you can put resistor in emiters of differencial pair to get local feedback.
This transformer is better to use with this amplifier:
http://www.diyaudio.com/forums/solid-state/162043-mosfet-amplifier-irfp240-irfp9240-25.html
Regards
hi apex,
for Q1 and Q2 is it supposed to be npn as BC546 is npn or in the schematic it is supposed to be another type of transistor?
Regards,
for Q1 and Q2 is it supposed to be npn as BC546 is npn or in the schematic it is supposed to be another type of transistor?
Regards,
Hi..Apex..thanks alot yours sharing this H100...Please give this schematic value componen and layout PCB .....
I must made some improvment in VAS. Mosfet output stage in class H can be used in other amplifiers.
Regards
Attachments
For class H step driver fets is better use IRFP140/IRFP9140. This step driver can be add on amplifiers with BJT outputs also.
hI Miles,
I have built the ckt using the pcb in post#33 , using +/- 48 psu unloaded but I'm getting +44v in the output ( reference to gnd) connecting ground wire to the input the same result. Replaced the tl071 and bd139 but also the same. I've used the specified tranny IRF240/IRFP9240, is the yellow LED supposed to lit when the amp is normally operational? Do you have some guide on what should be the nominal voltage reading in the particular point on that circuit if there are that will be a big help in the troubleshooting.
Regards,
Stcboy
I have built the ckt using the pcb in post#33 , using +/- 48 psu unloaded but I'm getting +44v in the output ( reference to gnd) connecting ground wire to the input the same result. Replaced the tl071 and bd139 but also the same. I've used the specified tranny IRF240/IRFP9240, is the yellow LED supposed to lit when the amp is normally operational? Do you have some guide on what should be the nominal voltage reading in the particular point on that circuit if there are that will be a big help in the troubleshooting.
Regards,
Stcboy
You must connect separate ground wire from PSU to input GND. Yellow LED lit when the amp is normally oprational.
Regards
