Ceasar II 300B SE mono block upgrade Part #2
Posted 24th July 2012 at 06:01 PM by dvb projekt
Updated 13th November 2015 at 10:41 AM by dvb projekt (New photo source)
Updated 13th November 2015 at 10:41 AM by dvb projekt (New photo source)
A short quick upgrade for my Ceasar II Mono´s
to push the sq to the limit...
In the meantime...
As you could see in the Upgrade Part #1, the printing of the Sophia Electric Royal Princess 300B
is 90 degrees different to the Emission Labs 300B-XLS.
Not a big thing, but it´s not looking good!

Unfortunately i have only two holes for the Tube-Socket. Therefore i made two small adapter to rotate the Tube-Socket.


Now the printing faces to the front!

Perfect!

to push the sq to the limit...
In the meantime...
As you could see in the Upgrade Part #1, the printing of the Sophia Electric Royal Princess 300B
is 90 degrees different to the Emission Labs 300B-XLS.
Not a big thing, but it´s not looking good!

Unfortunately i have only two holes for the Tube-Socket. Therefore i made two small adapter to rotate the Tube-Socket.


Now the printing faces to the front!

Perfect!

Total Comments 0