The PSU case
Posted 17th April 2011 at 11:45 AM by dvb projekt
Updated 30th November 2016 at 09:58 AM by dvb projekt
Updated 30th November 2016 at 09:58 AM by dvb projekt
Finally the engraved top-, front- & backplate arrived.
Surely you are asking yourself, why i made a 1mm deep square around the place for the transformer...
...now here is the answer
I´ve got a perfect aluminum transformer housing and now it sits perfect without an air gap.
Now it´s time to assemble the parts.
Surely you are asking yourself, why i made a 1mm deep square around the place for the transformer...
...now here is the answer
I´ve got a perfect aluminum transformer housing and now it sits perfect without an air gap.
Now it´s time to assemble the parts.
Total Comments 5
Comments
-
Damn Oliver that looks awesome. All the stuff you build looks good!Posted 17th April 2011 at 04:08 PM by Bas Horneman
-
Hi Bas,
thanks for the compliment!Posted 17th April 2011 at 04:28 PM by dvb projekt
-
looks cool!
question - where you order engraved?
What company does that?
What site do it?
Thank you.
VyacheslavPosted 23rd August 2012 at 05:42 PM by Vyacheslav
-
Hi Vyacheslav,Quote:Originally Posted by Vyacheslav
looks cool!
question - where you order engraved?
What company does that?
What site do it?
Thank you.
Vyacheslav
what you need to do first, is the design for the case plates with the Front Panel Designer from Schaeffer AG in Berlin.
After that, you sent your naked case plates to them. Normaly you get them back within 14 Days.
Cheers,
OliverPosted 24th August 2012 at 07:41 AM by dvb projekt
-
Thank you very much!
Vyacheslav. Ukraine. Dnipropetrovsk.Posted 9th September 2012 at 08:56 PM by Vyacheslav
