Go Back   Home > Forums > Blogs > HumbleDeer

Rate this Entry

iNuke received!

Posted 7th February 2017 at 09:35 PM by HumbleDeer


Just yesterday evening, I received my iNuke NU3000DSP.

I've been playing around with it for a while and I absolutely love playing with the settings. I've tried out almost everything and even as a main driver it'd sound better than my current amp.

i've made speakon connectors already, but the xlr plugs aren't working. Can someone help me set up how to connect an unbalanced source like seperate RCA's to two XLR's? Like one XLR plug with the White RCA and anothe one with the Right. The pinout is confusing as some don't state Viewed from the from or Viewed from the back.

Cheers, though. I love this amp for subwoofer duty.

Posted in Uncategorized
Views 438 Comments 1
Total Comments 1


  1. Old Comment
    gkh's Avatar
    On most XLRs you can find pin numbers from 1 to 3, usually on the solder side.
    For asymmetric connection, bridge pins 1 and 3 and connect them to the screen of your cable; pin 2 is "hot", and connected to the core.
    Posted 11th April 2017 at 05:50 AM by gkh gkh is offline

New To Site? Need Help?
Copyright 1999-2017 diyAudio